FTDX-3000 HF/50MHz Transceiver *SAVE £100*
- *ONE ONLY SPECIAL PRICE*
Yaesu FT DX 3000 HF/50 MHz 100W Transceiver
The FT DX 3000 Transceiver is the newest additions to the Yaesu family of fine Amateur Radios, incorporating down conversion and sharp edged crystal roofing filter technology. These features provide outstanding receiver performance which is a handed down heritage of the FT-DX5000. The FTDX3000 transceiver incorporates many other new features in a compact housing using a 3.5" TFT screen for displaying operating frequency, mode and other essential operating information.
Rugged 100 Watt Output Power
The Amazing Crystal Roofing Filter performance has been proven in the FT DX 5000
The Down conversion 9 MHz 1st IF frequency receiver construction can realise narrow 300 Hz (optional), 600 Hz and 3 kHz bandwidth roofing filters.
Implementing the extra sharp Crystal Roofing Filters provides superior close-in dynamic range and affords the best receiver performance possible.
Outstanding Receiver performance is the heritage of the FT DX 5000
The Essential elements in receiver performance are the RF amplifier and the 1st mixer.
The RF Amplifier has optimized NF points, and the over-sized wide range RF transformer exhibits minimum saturation in strong signal processing. The optimized devices were selected to guarantee superior multi-signal RX performance.
The desired maximum performance has been realized in the development of the FT DX 3000 receiver circuitry. This new radio has the high dynamic rance IP3 performance that was realized and proven in the FT DX 5000.
IF DSP provides effective and optimized QRM rejection
The 32 bit high speed floating decimal DSP (max 2800 MIPS) provides effective cancellation/reduction (DNR) of the random noise that is frequently found on the HF Frequencies.
Auto-Notch (DNF) that automatically eliminates the dominant beat tone
CONTOUR and APF; very effective receiver noise reduction tools in the HF band operations.
Yaesu original DSP QRM and noise reduction are also provided with the new FT DX 3000.
Large and Wide Colour LCD Display
The high-resolution (480 x 272 dots) 3.5-inch wide colour LCD displays the operating information and the status of the transceiver functions.
The various FT DX 3000 functions are displayed on this LCD and provide the operator with easy to read operating information.
High Speed Spectrum Scope built-in
Although the FT DX 3000 only has one receiver, a high speed Spectrum Scope is built into the radio.
When in Auto Mode, the Spectrum Scope display is updated in real time.
The maximum bandwidth of the scope is 1 MHz, and the minimum span width setting is 20 kHz. The best desired span is selectable for the high-resolution display. The current band activity can be monitored in real time.
AF SCOPE display and RTTY/PSK encoder/decoder (optional)
The optional AF SCOPE and optional RTTY encoder/decoder functions have been developed for the FT DX 3000.
The wave form of the AF SCOPE signal can be displayed on the TFT LCD. Also, the RTTY/PSK text may be displayed on the LCD.
Independent Frequency Display
The Main operating frequency is the most important display in the radio, with VFO-A frequency located just above the main dial.
The newly-developed LCD has a wider viewing angle and higher contrast for convenient and effortless viewing.
- Built-In Specialised Receiver amplifier for 50 MHZ
- Three antenna connectors are provided, with the possibility of assigning the "ANT-3" connector to "RX-Only"
- Signal output for an external receiver
- 9 MHz IF output
- High Speed Automatic antenna tuner built-in
- Optional µ-tune unit available
- USB Interface
- FT DX 3000 Transceiver
- Hand Microphone
- DC Power Cord
- Operating Manual
- Warranty Card
FT DX 3000 Transceiver
GENERAL Rx Frequency Range 30 kHz - 60 MHz (Operating) 1.8 - 54 MHz (Specified performance, Amateur Bands only) Tx Frequency Range 1.8 - 54 MHz (Amateur Bands only) Frequency Stability ±0.5ppm (after 1 minute @ -10ºC to +50ºC) Operating Temperature Range -10ºC to +50ºC Emission Modes A1A (CW), A3E (AM), J3E (LSB,USB), F3E (FM), F1B (RTTY), F1D (Packet), F2D (Packet) Frequency Steps 1/10Hz (SSB, CW, AM), 100Hz (FM) Antenna Impedance 50Ω, unbalanced 16.7Ω - 150Ω, unbalanced (1.8 - 29.7 MHz) 25Ω - 100Ω, unbalanced (50 - 54 MHz) (Tuner ON, 1.8 MHz - 50 MHz Amateur bands, TX only) Power Consumption Rx (no signal) 1.8 A (approximate figures) Rx (signal present) 2.1 A Tx (100W) 23 A Supply Voltage DC 13.8 V ±10% (Negative Ground) Dimensions (W x H x D, mm) 365 x 115 x 312 Weight (approx, kg) 10 TRANSMITTER Power Output 5 - 100 Watts (2 - 25 Watts AM carrier) 5 - 50 Watts (AM carrier) Modulation Types J3E (SSB): Balanced A3E (AM): Low-Level (Early Stage) F3E (FM): Variable Reactance Maximum FM Deviation ±5.0kHz/±2.5kHz Harmonic Radiation Better than -60dB (1.8 - 29.7 MHz Amateur bands: Harmonics) Better than -50dB 1.8 - 29.7 MHz Amateur bands: Others) Better than -65dB (50 MHz Amateur band) SSB Carrier Suppression At least 60dB below peak output Undesired Sideband Suppr. At least 60dB below peak output 3rd-order IMD -31dB @ 14 MHz 100 watts PEP Bandwidth 3kHz (LSB/USB), 500Hz (CW), 6kHz (AM), 16kHz (FM) Audio Response (SSB) Not more than -6dB from 300 to 2700 Hz Microphone Impedance 600Ω (200 to 10kΩ) RECEIVER Circuit Type Double-Conversion Superheterodyne Intermediate Frequencies 9.000 MHz / 30 kHz (24 kHz for AM/FM) Sensitivity SSB (BW: 2.4 kHz, 10dB S+N/N) 4µV (0.5 - 1.8 MHz, IPO "ON") 0.16µV (1.8 - 30 MHz, RF AMP2"ON") 0.125µV (50 - 54 MHz, RF AMP2"ON") AM (BW: 6 kHz, 10dB S+N/N, 30% modulation @ 400 Hz) 28µV (0.5 0 1.8 MHz, IPO"ON") 2µV (1.8 - 30 MHz, AMP2"ON") 1µV 50 - 54 MHz, AMP2"ON") FM (BW: 15 kHz, 12 dB SINAD) 0.5 µV (28 - 30 MHz, AMP2"ON") 0.35 µV (50 - 54 MHz, AMP2"ON") * There are no specifications in frequency ranges not listed * Selectivity (WIDTH: Centre) Mode -6db -60dB CW/RTTY/PKT 0.5kHz or better 750Hz or less SSB 2.4kHz or better 3.6kHz or less AM 6kHz or better 15kHz or less FM 15kHz or better 25kHz or less Image Rejection 70dB or better (1.8 - 30 MHz Amateur bands) 60dB or better (50 - 54 MHz Amateur band) Maximum Audio Output 2.5W into 4Ω with 10% THD Audio Output Impedance 4 to 8Ω (4Ω: Nominal) Conducted Radiation Less than 4 nW Specifications are subject to change, in the interest of technical
improvement, without notice or obligation, and are guaranteed
only within the Amateur Bands.